Check Yardian's LED Status. Yardian should be in Wi-Fi AP mode to proceed (LED blinking in Green and Blue)
For iOS users, please turn on Wi-Fi on your mobile device.
For Android users, please allow Yardian App to access the device’s location to get a list of available networks.
If Yardian is not blinking in Green and Blue, please press the Wi-Fi reset button for around 5 seconds and release when you see the LED blinking in Green and Blue.
Note: LED in purple!
If your Yardian is in Wi-Fi AP mode for more than 15 minutes, you will be asked to reboot Yardian (Press Wi-Fi Reset Button until LED turns red).
From the App, click the Yardian Card and go to "Wi-Fi Onboarding":
Step 1. Select the Yardian SSID.
The Yardian App will scan the nearby wireless signals to provide you with a list of wireless networks for you to choose.
Step 2. Choose the network you normally use and input your Wi-Fi password.
This step applies to Android.
Specify your home Wi-Fi router SSID # and password.
This step applies to iOS.
Specify your home Wi-Fi router SSID #.
Enjoy Using Your Yardian Controller
You have successfully linked your Yardian to your Wi-Fi network. Controlling your sprinkler system over the phone is only 1 step away.
You can Continue to use the Yardian App.