Yardian Pro Wi-Fi Onboarding Troubleshooting for Android

Wi-Fi Onboarding Requirements

• Please allow Yardian App to access the device's location.

• If Yardian is not in Wi-Fi AP mode (LED blinking in Green and Blue), please reset Wi-Fi setting:

  Press the Wi-Fi reset button for around 5 seconds and release when the LED is blinking in Green and Blue. Yardian will be under Wi-Fi AP mode and the LED will be blinking in Green and Blue.
  
  

Can not find my Yardian SSID in Wi-Fi Onboarding Step #1?

• Please make sure your Yardian is powered on and in Wi-Fi AP mode (LED blinking in Green and Blue).

• Please make sure you have the Wi-Fi dongle attached.

• Please make sure Wi-Fi is turned ON on your mobile device.

• You might be too far away from Yardian's Wi-Fi signaling range.

LED in Purple

If your Yardian is in Wi-Fi AP mode (LED blinking in Green and Blue) for more than 15 minutes, you will be asked to reboot Yardian by pressing Wi-Fi Reset Button until LED turns red.

When you see Green LED light blinking during/after Wi-Fi onboarding setup, not to worry! 

This means Yardian is in Wi-Fi Station Mode and is trying to connect to your Wi-Fi router. There may be a couple of reasons if it keeps blinking in green:

1. Please make sure you are using 2.4GHz Wi-Fi router.
2. If you have a dual-band Wi-Fi router, please make sure the SSID is on 2.4GHz.
3. Check if there is a typo in your password (or wrong Wi-Fi SSID/password combination).
4. Check if the Internet access to your Wi-Fi router is normal.

Still failed to connect to my router

• Please go to your Wi-Fi Setting from your mobile device, remove (forget network) any "Yardian SSID", then try Wi-Fi onboarding again.
• You can also use a USB drive to get your Yardian online.

Back to Wi-Fi Onboarding Troubleshooting