Wi-Fi Onboarding Requirements
Please allow Yardian App to access the device's location.
If Yardian is not in Wi-Fi AP mode (LED blinking in Green and Blue), please reset Wi-Fi setting:
Press the Wi-Fi reset button for around 5 seconds and release when the LED is blinking in Green and Blue. Yardian will be under Wi-Fi AP mode and the LED will be blinking in Green and Blue.
Can not find my Yardian SSID in Wi-Fi Onboarding Step #1?
Please make sure your Yardian is powered on and in Wi-Fi AP mode (LED blinking in Green and Blue).
Please make sure you have the Wi-Fi dongle attached.
Please make sure Wi-Fi is turned ON on your mobile device.
You might be too far away from Yardian's Wi-Fi signaling range.
LED in Purple
If your Yardian is in Wi-Fi AP mode (LED blinking in Green and Blue) for more than 15 minutes, you will be asked to reboot Yardian by pressing Wi-Fi Reset Button until LED turns red.
When you see Green LED light blinking during/after Wi-Fi onboarding setup, not to worry!
This means Yardian is in Wi-Fi Station Mode and is trying to connect to your Wi-Fi router. There may be a couple of reasons if it keeps blinking in green:
- Please make sure you are using 2.4GHz Wi-Fi router.
- If you have a dual-band Wi-Fi router, please make sure the SSID is on 2.4GHz.
- Check if there is a typo in your password (or wrong Wi-Fi SSID/password combination).
- Check if the Internet access to your Wi-Fi router is normal.
Still failed to connect to my router
- Please go to your Wi-Fi Setting from your mobile device, remove (forget network) any "Yardian SSID", then try Wi-Fi onboarding again.
- You can also use a USB drive to get your Yardian online.
Back to Wi-Fi Onboarding Troubleshooting
Article is closed for comments.